Recent content by Rob_W

Having trouble calibrating Skyview compass in Flight Design CTLS. When in the calibration section (ground), says it needs a GPS signal but do not know why it does not have one. Updated seven inch displays in other aircraft OK. The CTLS also has a Garmin 695 in the panel. Rob_W

How to electrically connect to a Dynon D-100 to update the firmware? There is no USB port. The instrument is currently in a Technam Echo Super. Rob W

Just to finalize this blog, the problem turned out to be that one of the Skyview displays had been replaced, perhaps very early during test phase, and this had not been recorded in the log book. Hence the unlock code did not correspond to the actual display serial number. Once this was detected...

Found that one Skyview display had been replaced and not noted in the Logbook. Some think this replacement sometimes happened when the aircraft was undergoing acceptance tests after manufacture. Hence the wrong serial number was being used. The unlock file is according to serial number. When the...

jakej Aircraft is in Benalla. I live in Melb (Ivanhoe). 94994275

I cannot update the screens separately. Buttons 7 and 8 do nothing on the right screen. The whole package works on the left screen with all the EMS etc compressed on to that screen. I have tried disconnecting the LHS electrically and then sometimes I get a result from 7 and 8. But as it starts...

Hi I have tried to update the firmware in my Dynon D1000 Flight Design (SV--D1000/2513 and SV-D1000/2543) CTLS but get the ASAHRS fail, EMS fail on both screens. Initially the RH screen was normal but rebooting resulted in the above. I suspect the two screens have two different versions of the...

Hi I will be coming to the US soon. Can I bring the two Skyview displays and have them serviced and updated at Dynon?

Have Flight Design CTLS with constant speed prop and autopilot. About 2009 vintage.

When attempting to upload firmware update Skyview-14_0_7_3621-dynon_update.dup, I get an error message: "Must be in DUC file with password" What does this mean and how to proceed? What password is needed? Have 14_1_1_3678-dynon_update.dup now on a USB stick. Have noted from some of the forum...

It is a Skyview system. Did not notice this was a section for the D1. Will change. However, have noted that I was uploading a dup file, not a cup file. Will attempt to upload a cup file and then the dup file? However CUP file is for USA, not Australia. Updates have not been done for many years...

When attempting to upload firmware update Skyview-14_0_7_3621-dynon_update.dup, I get an error message: "Must be in DUC file with password" What does this mean and how to proceed? Have 14_1_1_3678-dynon_update.dup now on a USB stick. regards Rob W