Recent content by Ron_Wullaert

I have the same issue since the latest update of the Skyview software to the latest version

I use a USB drive to store flight plans on but its not a SanDisk brand.

Thanks for the suggestion. I sent them an email already

On the last couple of flights, we experienced a failure of the main panel in mid-flight. Before the start and during the first part of the flight, everything is working as it's supposed to. Then in a flash, the main screen lights up with a white background (see the attached picture). To resolve...

I have installed version 15.3.4 this afternoon and performed a test flight. This time I've experienced 2 restarts during the flight.

Sorry for the late reply. We did find an issue with a bad connector from the hydraulic pump for the landing gear. That, however, help to resolve the issue with one of the displays. The second display is still suffering from hangs & reboots. It does come up when we perform the hard reset (1/2/5)...

Just recently I've been having some intermittent power on failure of one of my SV-D1000 screens. I have a setup of 2 SV-D1000 screens. Sometimes one of the screens goes on normal when the avionics bus is powered up, but on some occasions the left screen stays black like it doesn't get any power...

Thanks for the update Don. I’ll get in touch with Trig to get the software update. Thanks for the great support!

Thanks for the support. Let’s hope Trig can come up with a solution.

Okay great! Thanks Don Do you want me to call you when i’m Near the airplane to do some testing?

I have a correct readout for all the .25 frequencies. The red-X only appears for 8.33 frequencies. So the serial port is not the issue.

I have a dual classic Dynon screen configuration running the 15.3.3 software. My radio is a Trig TY91. Whenever I select a 8.33 frequency, the COM status will go INOP by red-X. Reselecting a .25 freq will simply restore the COM bar. Anyone else has seen this issue?