Recent content by Spunk

6B

Same issue here.

You can use a uAvionix tailBeaconX with an AV-30-(E or S) to control it. AV-30-S is needed for a certified installation. AV-30-E is for experimental. Also for experimental you can use the AV-20-E. It would be great if we could control it using the HDX. I wonder if an Avidyne could control it...

I'd really like a yoke mounted one. Being an airline guy, it's always been on the yoke. I figure at the end of an approach I'd get super confused as to where it is!

I don't plan to drill anything into the yoke. I'm going to try to design and 3D print custom clamps to hold the switches and housing on the upper left side of the yoke.

Is yours screwed to the yoke?

It seems that Otto switches are really popular.

I'm just about to have my autopilot installed in my 1965 Cessna 182H and was wondering what people have for yoke-mounted disconnect switches. What switch are you using (where did you get it, what type) and how is it mounted on your yoke? Pictures would be great too! I'd like to 3D print some...

Awesome, thanks! That's probably what we'll do.

What do folks do with the unused tachometer drive after installing the magneto-driven tach for the Dynon? Is there a cap that can be placed on it? Do you remove it completely and put in a plate or something to cover the hole (although that would be tough without removing the engine)?

True, I mentioned this above.

By Dynon EFIS, do you mean the EFIS-D10A? I talked with Dynon today and they don't have anything that controls the tailBeaconX but I only specifically asked about the HDX.

***UPDATE*** It is my understanding that the AV-20-E is experimental only and is the only 2" display that can control the tailBeaconX. The AV-20-S is the certified version but does not control the tailBeaconX. The certified AV-30-C (3" display) does control it. Also, I talked to Dynon today...

I'm using Dynon's ADSB In (SV-ADSB-472). Now that I think about, I wonder if that will work. Does the HDX need the Out from the Dynon transponder to make the In work or can I use any brand Out transponder?

So, in a fortunate turn of events since I wrote the original post for this thread last year, my avionics installer forgot to buy me the Dynon transponder for my panel upgrade. Now I'll be able to get the tailBeaconX, which has been out since April. It's a great product and currently the best and...