Search results

Update, the arnc429 module was wired incorrect install shop never checked their work, they said they were given wrong wiring diagram. Lots of other problems. Dont pay until you verify everything, take a week if you have to. These guys are “installers”, apparently whether things work after...

Ok i tried again and things are working better, bur still no magenta /white flight plan line on skyview moving map. Also the leg shown active on garmin is not shown active on skyview. It is interesting to note that user waypoints on skyview are truncated from what shown on garmin, Photo...

Very interesting. I did attemp to activate on garmin to remedy but not navigate on skyview i will try this this afternoon. I am pretty clumsy with garmin so i need to try all over to diminish operator error. Thank you to all.

Ok got it, at this point i need to look at installation. Ive thoroughly read hdx operating manual and i will look at garmin again. But i am already doing those things perscribed above. I am getting garmin as flight plan source tab ootion but not getting flight plan on moving map or on flight...

Carl, are you able to see gtn650 listed waypoint sequence on hdx flight plan screen. Do you need to load or activate on gtn before being able to see sequence on hdx?

FP for flight plan. A garmin GPS 175 is installed for IFR gps. Also a gnc255. I am not IFR certified yet and am trying to figure the Garmin gps/hdx relationship out. If I have gps 175 as flight plan map source I assume the HSI /CDI source should also be GPS175. Is there ever a reason to have...

New avionics, new pilot: can someone help explain which choice is correct, having ext gps source for map FP and SKYVIEW source for HSI or have both the same? My instinct is to have both source the same but without reason.

Thanks ken. That describes what i was confused about. I would prefer the SB option not be displayed as brg source (brg location?) if there is no actual frequency signal associated, no value added. In the end it might be easy to ignore but at this moment it annoys me. I think i will see if dynon...

Thanks, you are on same page. Ive done that. Ive checked all serial ports. I will check again for device input list tomorrow. I labelled port 3 as gnc255 not gnc255sb. my avionics shop told me that sb stands for stand by. Makes no sense to have nav stand by frequency show up as brg source. Ill...

Naw, at setup i labeled the source gnc255. I have no idea where gnc255sb came from. I was hoping somebody else had same experience. It only shows under brg

Update. Ended up being system setup for rs232 port. Hsi now works. Problem resolved except now for brg source i get gnc255sb and gnc255 option. The gnc255 brg source does point correctly to signal point. The gnc255sb (stand by?) doesnt appear to do anything. Does anybody know why dynon is...

Thx rhino. I was using audio panel. But didnt hit nav ident on garmin 255. My msin problem is showing the source nav signal on the hdx. Its like somebody cut the wire

New installation HDX and garmin 255 nav/com. Following instruction when nav 1 is select as brg source VOR not showing on HSI or under source. the vor is identified on active nav but did not hear morse code. Operator error real possibility but i think im doing everything correct and brg pointer...