Search results

What garmin gps are you using? I am using a garmin 496 handheld using the latest 4.10 firmware, but there is no mention in the release notes of the fixes you mentioned. I did notice that the firmware for the Garmin 296 and 396 handhelds was no longer in the updates. Dont know if they just...

I have had my ACE connected for a long time now. I plug my ACE serial port into the Dynon serial connecter that is used to update the Dynon. Works great.

Make sure your GPS advanced interface is set to 'Normal". If it is set to "Fast", you wont be able to use the "Nav" function. When you are in setup and in the tab when you set the baud rate and interface type, press the MENU button once to bring up the advanced screen to see whether your gps...

I am assuming with the synthetic vision, that the Skyview system knows the altitude of the ground below it. So, how about putting the altitude AGL at the bottom of the altitude tape?

www.starkavionics.com

Just another quick thought. The virus software I was running had disabled comm through the com ports and I had the same typoe of error. After I set the virus software to allow data through the comm port, it started to work.

Swap Com 1 to the Dynon and then com 2 to the Navaid and that will tell you if its the GPS that is causing the problem. You can also drive both the Navaid and the Dynon D10A from Com 1. Regards, Tom Velvick

Can you hook up pin 15 through a switch so you only turn it on for startup? Regards, Tom Velvick

Hi Mike, I have two thoughts on your bracket. 1) Maybe its the Vans bracket that is off slightly, so that's why they dont match. 2) I would make one of the brackets over myself to make them both match. I wouldn't take a chance on having any problems with any part of this linkage. It's too...

When you use the Dynon Product Support Program to connect your PC to the EMS and use a USB to serial adapter, what should the serial port on the PC be configured to for the following settings? baud rate data bits parity stop bits flow control Use FIFO buffers (yes or not) Regards, Tom Velvick

My understanding is that the five wires remain the same and the extra two wires are for an additional DSAB bus.

Since it all started with the D10s, then went to the D100s, I wonder if the new ones will be D1000s or maybe D200s? Regards, Tom Velvick

Dynon support gave this answer in the "Prewiring for the Dynon AP" thread. What you need is 5 wires: 1) +12V, at 2amps. You'll need to size this wire for your run length. 2) Ground, at 2amps. You'll need to size this wire for your run length. You can ground this locally to the airframe if you...

Will the new AHRS eliminate the dependency on airspeed in determining a stable attitude solution for the EFIS? Best Regards, Tom Velvick

I keep finding out something new about my units that I didnt know! Thanks Dynon.

Add me to the "I want one" list,too. Tom Velvick RV-4

In these days of increasing avgas prices, it sure would be nice to have a MPG display on the fuel page.

Thanks Dynonsupport! I will update the EMS this weekend. Regards, Tom Velvick

Not sure just what the difference is between 4.0 and 4.0.4 Log says "New build with EMS-only changes" Does Dynon recommend that you update 4.0 firmware to 4.0.4 for Efis D10a and EMSD10? Regards, Tom Velvick