Search results

Hi All, Has anyone with a LS configured their Skyview to display the amount of ignition advance as output on pin 3 of the LS output connector? Any tips? Craig

Hi, Since replacing my engine driven fuel pump I am seeing fuel pressure readings of 13-14 PSI - versus the 4 PSI expected.  I connected a mechanical gauge to the line and it reads 3-4 PSI. I found an older 0-80 PSI transducer which indicates 4-5 PSI so it is definitely a issue with the...

Hi All, Trying to decide on roll servo replacement on my flying 6- under seat vs. wing. I know that proponents of wing placement often cite unwanted pitch inputs as a risk of under seat placement. This seems possible given the mechanics of the control rods BUT what I am interested in is...

Hi all, I currently have both network ports in use for my ADAHRS and EMS. I am adding A/P servos and I was planning on putting a hub near the pitch servo to share the network cable that connects the ADAHRS and minimize the new wiring I need to add for the servo. It occurs to me though that I...

I get an X at the top of the screen. I have my GTX327 receiving altitude information from my Skyview and of course have TX out of the 327 to the same Skyview serial port. I set the Skyview to expect GTX327 IN and set the GTX to REMOTE for output. I'm currently running 5.1. Thanks, Craig

I'm still having erratic RPM readings but only from the left mag. I've increased the resistor on that line from 30k to 100k ohm. Zero improvement. If I run only on the right mag, the RPM is stable. On either the left or both, RPM fluctuates RAPIDLY by 1500+ RPM. Anything else I can try...

Dear Dynon Support, I'm having three issues which I had thought were unrelated but now I'm wondering. All three seem RPM related only exhibiting issues above ~1000 rpm. Turning off the alternator or switching to either mag has no effect. 1) Serial port errors on all three ports in use. The...

Support, Can I connect Skyview audio out to the Unswitched inputs on my PS Engineering PM3000 intercom or do I need to use my entertainment input? Regards, Craig

I've JUST completed my Skyview installation and noticed a couple of things: 1). Unless I start the 496 up and have it ready to navigate BEFORE powering up the Skyview,  the Skyview does not receive the GPS data.  Only the receive line is connected on serial port 1. 2) With Synthetic vision on...

Is it mandatory or just extremely desirable?

Dear Dynon, I am replacing the DPS Instruments SmartTach as part of my Skyview upgrade. From the instruction manual it is difficult to confirm if it is using the standard or low voltage level for RPM measurement. The manual does reference that the voltage should cycle from 7/10v to 5+V so...

Hi, If I am reading the installation manual correctly, I can connect an OAT to the EMS module for cabin temp but in order to calculate TAS, etc, it needs to be connected to the ADAHRS. Is this correct? Regards, Craig