Search results

Initial install..no problems. After a couple of engine starts and skyview database update attempt, I got a message about previously recognized skyview modules no recognized/found. Had to exit update, did a network config check and found that the servos were no longer listed and can not get...

OK, I can select style and size of a widget for my sensor, but I am unable to move or place the widget where I want on my screens...what's the key??  Tried using the cursors after selecting the widget but no luck...  Any help would be appreciated...Thanks!!  OK got it figured out...I wasn't...

I am setting up my sensor mapping primarily like the Lycoming/Continental 4-cylinder fuel injected connections depicted in the Dynon installation manual. I am running a ULPower 350iS (old style ECU) which required two red cubes to provide fuel flow in and fuel flow out to provide fuel use rate...

Hey Dynon Gurus... Page 7-8 of install guide suggests using pin 6 for fuel pressure and pin 8 for oil pressure sensor inputs.. I am setting up mainly per the Lycoming/Continental 4-cylinder Fuel Injected table (page 7-15) which has the sensor connection just the opposite. Does it matter, if...

Looking for voltage output as a function of pressure from the sending unit.  How can I correlate the Dynon part number to the Kavlico model?  Then I assume I can find the documentation on the Kavlico site?  Thanks! Never mind...found the part number on the housing and the appropriate data...

Starting to wire up my engine sensors to the EMS 220 module.  The CHT and EGT seem straight forward.  For the other sensors; Red cubes FT60 (2), engine oil pressure, fuel pressure I need to provide power and ground for them to output signal into the EMS 37 pin harness.  Can I utilize the aux...

I have read the posts, but would appreciate a forum opinion or Dynon input. I would like to mount the the puck on top of the fuselage. I can achieve over three foot separation from my VHF antennae, but would place the puck within a foot of my ELT whip.  Typically, the ELT would not be an...

Hi Dynon Starting to route my servo and ADHARS network harnesses from the back end of the aircraft up forward to the panel.  In addition; need to route flap power, pitot power and comm RGA400 cable from the back as well. (1) Is it OK to "bundle" the servo and ADHARS harness together in the...