Search results

Thought so re 14 - FWIW, I never use those ‘cheap’ connectors & prefer dsub connectors for more essential to flight equipment like a/pilot servos & trim systems YMMV. ps - I have a customer who insisted on replacing the supplied wiring loom & replaced it with a straight through system...

That was a quick find, not always easy to troubleshoot ‘issues’. Was that on an RV14 ?

Did u do a system Configure to ‘ allow’ control of the servo ?

Contact Dynon Support, it's normally a damaged knob issue. Don't use contact cleaner least you create a bigger problem.

Some people have not connected pin 20 & the system still works as advertised - up to you.

"it is logical to run the flap sensor (a Ray Allen POS12) through the VPX " that way you have the ability to have flaps operate as momentarily or position based & have an audio warning if the flaps are partly down & your airspeed is going past your nominated flap extension speed. If your...

Pat, the MESSAGE button on the bottom RHS of the screen already 'acknowledges' the warning'. ALT light is for the Alternator, previous owner wanted to keep it that way.;)

I'd have thought that was obvious - Dynon use Trig for their Transponders too. Dynon don't build Tso'd equipment at this stage & maybe never need to.

Pay scale. ;) X25 is Tso'd.

Why doesn't it 'see' the Roll Servo' ? Did you do a system Config ? All wiring correct ? I wouldn't spend too much time over what you ask, it's more important to have both working, disconnect the Pitch servo & see what happens.

“Once the technology exist to protect people, then companies who refuse to include that technology in their products become liable if the inevitable happens.” I‘d suggest they would still be liable if the chute fails too.

Disconnect the 'keep alive' wire if you haven't done so, Dynon has said, many times, that it should be disconnected.

Galin - Not exactly sure what you mean here . I could have gone through the ARINC Conv however I went straight from my IFD to the a/pilot as the Dynon won't 'control' the a/p, you knew that anyway. I'll PM you.

Seems like it needs a re calibration ;) Damn, another excuse for you to go flying.

As Raymo says, however Dynon calls for it to be disconnected permanently.

Nothing 'fixes' itself, it just goes away to bite you another day - unless of course you did something unknowingly while checking connections etc that did 'fix' it ;).

Contact support@dynonavionics.com re the ADAHRS unit. Rain (water) - unless it is impacting the equipment it is not an element in the failure. Aircraft battery down to 9v when starting - have a battery load test done first & if good then check other things like main grounds ( I like to start...

Support@dynonavionics.com

Contact DS direct, the chances of a ‘poster’ seeing the same symptoms are zero IMO. The sooner you do that the sooner you can safely go flying again😉

Walt - make sure all Dynon devices are connected & powered on including a/ pilot. go into SV setup menu (buttons 7 & 8) then SETUP MENU>SYSTEM SETUP>SKYVIEW NETWORK SETUP>CONFIGURE. Just follow screen directions 😉