Search results

Need some help on the configuration for the SV-ARINC-429 so that I can select the GNS 430W are the HSI source in my Dynon Skyview system. Wiring connection is done as indicated by Fig. 153 in the Installation and Config. Serial RX (SV-ARINC-429 DB25 Pin 3) is connected to GNS 430W P4001 Pin 58...

This could be user error by me since it is the first time that I am trying to select a different HSI then the Auto Pilot in Skyview. I installed the ARINC-429 as shown in the installation manual figure 153 and connected the Serial RX (pin 3) of the ARINC-429 to GPS RS 232 OUT 2 (P4001 Pin...

I have been getting unstable readings for a number of items that are monitor through the SV-EMS. RPM and Battery voltage seem to be the most affected. It used to be mostly at full RPM, but today even at about 2000 RPM the readings were bouncing all over the place. Plus the AMP reading has...

I had not flown my plane for about 7 months. Finally did a flight and RPM, Fuel Pressure, Oil Temp and Battery Voltage were all over the place. With the RPM, once I go from full throttle to about 2300 RPM, RPM was stable. The others continue to be unstable. Any ideas?

AMP reading not working. I have the shunt that I bought from Dynon and the connection is made with pin 24 & 25 of the D37 connector. Most of the times it shows 94 AMPS and some times just dashes. I tied the wired for pin 24 & 25 together expecting to read 0 AMPS, but it was still 94 AMPS...

The current (AMP) display is not working correctly. It is reading 94 AMPS and I know that is not correct because if it was, the breaker would trip. I have the shunt connected between the alternator and the aircraft load. On one side of the shunt I have the EMS-37 pin 24 (orange/green) wire...

I turned on the engine on my RV-6A project for the first time and a couple of thinngs are not displaying correctly on the Skyview display. First, RPM reads 0. I have a Laser Ignition (PN LC-1001-04) for a Lycoming fuel injected O 360 A1A. I connected the EMS DB37 connector Pin 32...

I have a Lasar Electronic ignition installed in my RV-6A project. I have not installed the engine eyt, but want to make sure that I am wiring the EMS-220 correctly. I currently have the Right and Left p-leads conneted the EMS D37 connector pins 32 and 33 through a 30K ohm resistor. I noticed...

I am building an RV-6A. I installed a Skyview (10") system with EMS, AutoPilots, 1 ADAHRS, and ARINC-429. After installation I power the unit on for the first time yesterday and received 2 errors. ADAHRS Fail and Position Fail. For the ADAHRS Fail, I tried connecting it to the display using...

I am in the process of installing all the cables the Skyview system in my RV-6A project. I have looked at the installation guide, but I do have a question. First, here is how I was planning to do the connections. Display to SV-Net-3CC to SV-Net-SPL. The two ends of the SPL will go to the...

I am in the process of building an RV-6A (80% complete) and plan to install a 10" Skyview system, but I have a number of questions. 1) I do not see a probe or way to monitor RPM. How is this achieved? 2) I plan to also keep the traditional instruments on the panel, do you have recommendations...