Search results

Thankyou for your help. Jeff R Australia

I currently have 2 magnetos with R and L p leads connected to pin 32 and 33 on EMS plug for my classic Skyview. I wish to install 2 Emags on my Lyc IO 360, but am unsure if I take the wires from Pin 6 on each emag and connect to pins 32 and 33, or can I continue to use the wires already...

T Thanks Jake

Thankyou for your replies

I wish to add a Monkworkz Aux Alternator as a backup for my B and C Alternator. It will be in parallel to main alt and be wired on the switched side of battery contactor, using shunt as for main alternator. I am unsure which pins to wire the fusible links for this shunt , so I can monitor...

Thanks for your help

Shall do. Thankyou

The airspeed is calibrated, as is altitude, oat. I havent performed a magnetic calibration since initial install. Winds being off = almost always come from an angle from Left side of aircraft , mostly cross head wind , even when I know the wind may be from the Right( eg if Im laying off drift)...

I still find my winds a loft completely in error. I have installed latest Dynon sftware down load and confirmed the static lines are patent and attached to the rear ( Vans plans pulled rivet style) static ports, aswell as to ADHRS. Are there any other reasons why my ' winds aloft' indications on...

Seems resolved after changing 1A fuses

The latest Dynon. ( forgot the number). I’ll try your suggestion. Thsnks

Thanks for your reply. I shall have to go flying again, level wings on auto pilot and see if unloading the rudder keeps it level. When I hand fly with ball centred, it’s not apparent to me that I need elevator to keep wings level. The stick seems vertical.

I have an RV7a, with Dynon servos. The plane flies wings level with usually no aileron trim needed, but some R rudder trim with a tab on rudder to keep ball centred. When I turn on autopilot ( in simple mode) using HSI Track function, the left wing tends to drop (, ball stays in middle), and...

Thankyou . Will try that.

I have 375 hr Skyview Classic set up on RV7a. Yesterday the ammeter ( that usually reads 7 amps Alt output at cruise) alarmed and gave negative readings, with highly variable numbers. The voltage reading from my B&C Alternator remained steady at 14.3 volts . I concluded it was a loose fitting or...

Jeff, W[glow=yellow,2,300]hat do you mean that V13 fails to copy from your saved download to your USB storage? Do you mean a datalog to USB? Does it generate an error, or is the file you expect just not on the USB device when done? Hi, the ver 13.0.3 file that I saved in my Document folder ( on...

I have installed Skyview ver 13.0.2 and have downloaded Ozrunways map info and key on the USB stick. With the USB stick in the Skyview port, and on Map menu, pressing Layers fails to overlay Australian Hybrid VFR map as stated in instructions. Can any one proffer an explanation as to what I...

Serial Port setup for Flight Data Systems GD 40 Carbon Monoxide Detector. I have wired the above monitor as per Dynon Install Manual, but on setup can not find a relevant match for this device that warns of rising Carbon monoxide levels in cabin. Can you please advise how I set this up so I get...

Jake, I am unfamiliar with your term pm. Jeff R

I am connecting the pitch and roll servos to ( the yellow wire) to my Ray Allen 205 joy stick using SPDT switch #4, so it canbe used as rapid auto pilot disconnect . Dynons installation drawing shows a momentary operated switch which goes to ground to disconnect autopilot. Ray Allens 205 switch...