Search results
-
P
Complete System Failure In Flight
Did a short hop on Sunday with v14.05.3594 and had a shutdown of my 10" Skyview (#2248; hardware version 1). Got it back online via buttons 1, 2 and 5. Yesterday I uploaded the DDF and filled out the form using system event 3 (Do not know whether this is the correct description or not). Like...- p.vettel@gmx.de
- Post #91
- Forum: SkyView General Discussion
-
P
Knob-Panel not detected with SW version 14.0
It wasn't even listed in the status page. Got it fixed via a power cycle of my Skyview system with an unplugged knob panel network cable getting the unavoidable error messages. After I plugged in my knob panel and powered on again, it was recognized. So far so good. Thanks for your reply...- p.vettel@gmx.de
- Post #3
- Forum: SkyView General Discussion
-
P
Knob-Panel not detected with SW version 14.0
Hi All, Yesterday I changed the Software from 13.03 to 14.0. Recently (last weekend) I added 2 AP servos and the knob panel to my system. Works fine with SW 13.03. Now Skyview is not able to detect the knob panel. Any ideas? Regards, Patrick- p.vettel@gmx.de
- Thread
- Replies: 2
- Forum: SkyView General Discussion