Search results

I replaced the sensor and now everything is back to normal. Dan T.

FIXED :) Now the AP servos are connected to 'avionics'. (before were connected to 'master') However, while the engine is running if I want to reproduce the problem I switch on/off the 'master'(or 'avionics') a couple of times. Is it normal ? Dan T.

I get this error after I follow these steps : 1. master on 2. engine on 3. dynon on (avionics on) In order to get rid of the error I need to stop the engine and follow the steps again. It is very annoying since it is happening very often. (2 out of 5 times) Dan

The servos are connected to a 5A switch/fuse from ETA. Any ideas ?

Any idea ? This problem is really annoying. so, the order is : 1. master on 2. start engine 3. avionics on (dynon..etc ON) Sometimes I got only pitch or roll error. Thanks in advance ! Dan T.

Dynon, OAT is fluctuating from 25 to 31 degree Celsius. This problem appeared 2-3 hours ago. Have a look over this video : (look at DA and OAT) http://www.youtube.com/watch?v=YwtLnHP8QJA&noredirect=1 Any ideas ? Do I need to change the sensor ? Thank you ! Dan T.

What is your order of power up operations ==> Master ON, Engine ON, Avionics ON(When Avionics ON => Dynon + AP ON) Is the event related to engine cranking? ==> NO, I don't think so, If equipped with either an AP switch or breaker, have you tried turning them off and on (instead of restarting...

AP, Dynon Skyview, 10 inch, latest software(HSI + ALT) I get pitch/roll error on star-up very often. I need to re-start the engine in order to get rid of the errors. It is very frustrating. Is there a special trick ? Can I  touch or not the stick till Dynon starts us ? Any advice is much...