Search results

LiSflash, I dig up your old post. Have you keep your D180 with black screen ? I'm interrested for spares pièces. Off course depending of price and sipping costs to France. Jean Pierre jean.pierre.arrondeau@gmail.com

HI Can you send me you tube tutorials adress ? Thank you very much Jean-Pierre

Hi Oscar, I just join the "black screen when trying to adjust diming " club a few wek ago . I 'm close to send it to Dynon this winter but your mail open a new horizon . Is it realy a piece of cake to change the display ? without precise soldering ? I will enjoy your help !!! Jean-Pierre...

Thank you. JP

I have a EMS D120 installed on my experimental homebuilt DR250 (4 seater Jodel-Robin , IO 320). This EMS is an old "normal " (not super-) brighnes screen ... less and less bright. This EMS work fine (excepted brigtness). I have in mind two options : i- send the EMS to bee reparaided (I know...

Same for D120 ? So I didn't understand the previous answer in February( under). I hoped to see only main tank on main cluster, and the 2 small one on the aux page. May be with 0 as capacity for fl 2 ? My Jodel have 3 tanks. All with resistive senders. Main is 110 L, 2 and 3 (left and right...

Bonjour, about D120, firmware updated. In a previous post, I asked the question about the best way (ergonomic) to connect 3 tanks (1big central, and 2 small in the wings). After the precise answer, I decided to use Fuel level specialised entry to connect the main tank, and 2 GP (GP2 and GP3, -I...

Thank you.

I have in hand OAT sender (3wires). I understand I have to connect only yellow and blue wires to one GP input and to ground... But OAT cable is ended with small pins ( mini molex ?), and there is no plug furnished in my package. May I remove this small pins and use a normal " molex" - or...

Thank you... Jean-Pierre

My 3 fuel level sender are resistive senders (0-260 ohms). The potentiometer mobile (float) point is case grounded.  1 I understand I have only to connect B node to pine 20 to D120 ; true ? 2 For the third tank, I will connect B to pin 4 (GP 1) and also to pin 18 (5V) via a 200ohms resistor ...

Thank you. My back-mind (not sure of my English !) question was linked to the sentence quoted in the previous post, saying " there is no way to set tanks 3/4 separately from the first two". But your answer seem indicate there is no difference in term of calibration with the two options, only in...

My Jodel have 3 tanks. All with resistive senders. Main is 110 L, 2 and 3 (left and right wings) are 40L each. What would be the best connecting choice ? - 2 and 3 on GP buses, and only n° 1 to the specialized level connection ? or - main (n°1) on GP, 2 and 3 on level connection ? Blue skies...