Search results

I don't seem to have any good pics of the install but my MAP sensor is mounted on the hot side of the firewall and is connected to the #2 cylinder's primer port. I mounted the sensor a bit higher in elevation than the primer port so that any fuel/oil mist that condenses in the line pools at the...

Hi John, I have a Franklin 220hp 6A-350-C1R on my experimental Velocity. My A&P and I installed the EMS package on my engine a few years ago. Happy to help answer any questions.

Same here. My serial # are in the 11000-12000 range and still experience the random WiFi disconnect from time to time. Turning WiFi off and on inflight restores the connection but obviously not an ideal situation to say the least.

I have the same intermittent WiFi issue with my twin HDX setup. Works fine most of the time but perhaps one time in twenty the WiFi data stream will terminate (HDX WiFi itself is still active, just no data). I'm running FlyQ on an iPad mini in case that matters. As others have noted...

Hi, Not sure if I missed something in the manuals but is there a hot key to temporarily increase the EMS data log capture frequency while in flight so that a higher data capture frequency can be used? Normally I have the capture frequency set to record a data point once a second but it would...

Here's how I was able to get VB to recognize my USB drive for Win 7. Hope this helps.

This was indeed caused by a bad connection except the bad connection was one of the wires going into the sensor housing. My guess is that the wire had a bit too much slack and 300 hours of inflight forces fatigued it enough to break it as the wire pulled out of the housing with ease. Replaced...

During the last couple of flights, the carb temp sensor reading for my HDX became erratic and oscillated up and down randomly during the flight if the temperature inside the carb went below ~45F or so. The range that the temperature reading oscillates between looks to be about minus 20F below...

I can't seem to find the option in setup to configure the map button. In the HDX User's Guide, it states: "If not in flight, press-and-hold Buttons 7+8 (SETUP MENU) > MAP SETUP > MAP MODE > INC MAP RANGE > CLOCKWISE | COUNTERCLOCKWISE." I have firmware 15.4.7 installed on my HDX and my map...

According to their FAQ, Skyview is an app that runs on a customized version of Linux: https://wiki.dynonavionics.com/SkyView_FAQ#Since_SkyView_is_running_an_Operating_System_.28OS.29_-_however_much_it.27s_.22compact.2C_optimized.2C_stabilized.22..._can_it_be_.22rebooted.22.3F It seems possible...