Search results

Again, I realize this is not a feature. That is why I posted in the "Suggestions" topic area. Could this be implemented in the next firmware build for the EMS-D10? Simply default to 0' PA in the absence of a GPS altitude input.

Could both RPMs be added to the serial data stream in the next firmware build?

I connected the OAT ground wire to one of the pins you referenced. I don't recall which one. I understand this is not currently a feature of the D10, that is why I suggested it ;). This could be implemented in the next firmware build, correct?

I recently installed an EMS D-10 and found it a little difficult to look back in my datalogs and identify where my "mag-checks" were occurring. It would be helpful to have a record of the RPM being recorded on each input.

I recently installed an EMS D-10 and was able to connect the RS-232 output from my Apollo GX60 to the EMS. Unfortunately the EMS is not receiving altitude data correctly. It would be nice to have a %HP calculation that is based on sea-level. This would be conservative for my purpose...

I recently installed an EMS D-10 with the two wire OAT sensor. The OAT value reads ~3-4C higher than the ambient air in all situations (parked in hangar, taciing, in flight etc. It would be nice to be able to bias or scale the OAT reading in the sensor setup page.