Search results

So I have some wires to look at. You say audio will be poor if you put both displays together on one wire but 4-34 says you do connect both screens together and then to the audio panel. That's revision AG 5/21/2020 If there is more than one display on a SkyView network, you MUST connect all...

Went back and read it again, you're right. Like I said, I'm not doing and install I'm troubleshooting so I'm jumping into the deep end on this! I appreciate your help and your patience. Is it possible that in earlier versions this wasn't required? I wonder if it was wired correctly when...

Screen two boots up first. Screen two has good audio to my headset ONLY in audio setup screen. Screen one doesn’t give any audio in audio setup. Sounds like it may be hooked up correctly then, screen two boots first, it’s primary, it gives me audio in audio setup menu. So the question then...

Found this info in the install manual -- "SkyView systems with more than one display normally only output audio alerts from one display to minimize audio distortion." But then on the next page it says VOLUME CONTROL / TEST – Sets the volume level. While in this menu, sound is played...

Copy thanks. Not sure at this point if there's a way for me to tell. Panel was installed 4 years ago, I just got the plane. Maybe a wire got pulled from a pin. I'll dig into audio wiring schematic if I can find it and go from there. Thanks!

If one screen has the audio connection and the other does not will that inhibit all aural alerts? Screen 2 is wired to the intercom, I can hear that when I adjust the master volume. Alerts pop up identically on screens 1 and 2, so why would screen 2 just give me the aural alerts? And the...

I don't know, because in the audio setup menu on the Dynon Skyview when setting the master volume it repeats the boot greeting so you can set the volume right. That worked on screen 2, not screen 1. And sounded fine coming through the PS4000. So why get that but no warnings? The PS4000...

Hey gang. Not getting any audio alerts from my Dynon. Dual SV 7” screens. PS4000 intercom. When I go to settings on screen one the volume is up and everything is turn on, but I don’t get the boot greeting when I adjust the master volume. If I exit that, and go to settings on screen 2 I get...

Hey gang. Homework for my Garmin GPS175 install. On the back of my primary display (skyview SE 7") I have one open 9 pin port. Is that a SV-net port I can connect to the ARINC 429? Cheers

Copy. Thank you.

eu vi isso, obrigado. muito útil

Couldn’t find it in the manual. Can you use an open USB port on the back of the Skyview for power? For example to run an iPad? thanks y’all!

I’m excited to get one installed! AOPA had a column in their latest issue about it too.

Super, thanks for that! Just really need a mounting template before I spend money. Thanks again!

Hey y'all. Looking at installing a Garmin GPS175 so I'll have an IFR GPS. Panel is dual Dynon Skyview displays, Dynon AP and remote radios. Couple questions I can't find on search. Will the Skyview display glidepath indications for an apporach or do I need a seperate indicator? Does...