Search results

Oh well! I would rather direct my concerns to a administrator/moderator in private communication. I am new to this Forum having just the one post/question. One of the respondents; chriscalandro - At no time did he actually address my specific enquiry, preferring "shotgun" statements. Light on...

How do I contact the Forum moderator(s)

Chris - I know (hope) you are attempting to be helpful, unfortunately you are not. Your statements do not address the question. Are far to general in nature, repetitive & pedantic in tone. You do not read or take into account, the responses made to your suggestions. For this topic, this is my...

"With a return line, more than likely the only way to meter the fuel is with 2 transducers." Not correct! Read my comments above. Further I am reliably informed that several aircraft manufacturers' (eg Tecnam) install one sensor (Red Cube) and adjust the reading to accommodate the return line...

Yes & No - I purchased the incomplete, plans built, Sonex Legacy from the original builder and finished it. Under Australian rules, I am listed as the builder. It's been in the air for 132 hrs now. The aircraft came to me as an almost comprehensive "kit" in that I have had to purchase very...

"If that information is accurate, then the fuel flow itself must be accurate" Exactly what I would have expected, that does not seem to be what is happening. Read my opening statement. "They MUST BE CONFIGURED SEPARATELY AND INDEPENDENTLY." Once again you avoid the question - what...

I disagree - I have been specific in my question, you have been very general in your repeated response ie not addressing the question. I think you can infer from the information I have given, that I know how to change/adjust the calibration - I have achieved a satisfactory level of fuel...

I am sorry that you seem to be taking offence - perhaps you don't know the answer to my question. Will adjusting one cube pulse rate effect the reading of the other cube????

No offence Chris, you are not addressing the second part of my question - "....will the adjustment to the return line pulses, effect the main line pulses accuracy?" IE When I start changing the pulse rate of the return line cube, will I also have to adjust the pulse rate on the mainline cube -...

Thank you for your comment. You have addressed the first part of my question BUT what of the second. "....will the adjustment to the return line pulses, effect the main line pulses accuracy""?

Very disappointed - had a few "Views" but not a word of advice.👿

I have two fuel flow red cubes. One on main/delivery hose. One on return to tank hose. Followed Dynon instructions, I provisionally set both for recommended Rotax 912ULS pulses (70000??). Over several flight & refuels, to same level (full), I made adjustments to number of pulses on the...

Thanks Rhino. I am astonished by the fantastic service provided by Dynon Australia & USA. Not only did D. Australia proactively send me a "loaner" ADHARS, I found out yesterday that D. USA has repaired my unit and its on its way back and will be with me early next week.

The "loaner" works just fine. I am more intersted in any other failures that may be due to ambient temperature.

I am new to this Forum. My Dynon has the same failure sign as 704ch. My unit failed between working just fine, shutdown, return next day and pre engine start, check of fuel quantities FAIL!. Warm day about 38C I guess I should be thankful that it didnt fail in the air. Returned home and started...