Search results

I have a dual screen Skyview system with AP Panel, pitch & roll Servos, integrated with a GTN 650, Expert Mode. AutoPilot tracks a flight plan from the 650 perfectly. But when I activate an approach, the system intercepts the final course, but then switches from GPSS to GPS and tracks...

I asked about this feature several years ago. Any update? My original post is below The "Fuel at Waypoint" info item is useful but I would also like to have a "Fuel at Destination". I can calculate it now with the available information, but it would be nice to have a direct readout. As...

I'm trying to wire my EarthX BMS to Skyview and a separate panel warning light. Can't get either to work properly. Wired to C37 Pin 11, and configured as a contact. The Sensor Debug shows 4.998v, regardless of whether the BMS red light on the battery is on or off. I ran a wire to the battery...

Currently have an external level switch mounted on my panel, connected to SkyView D37, Pin 28. Planning to add an SV-AP-Panel and remove the external switch. Does the SkyView network provide power & control to the level button? I can't find any reference connecting the AP-Panel to D37, Pin...

Just want to confirm that it does not matter where components are wired into the network. All the examples show the EMS module connected directly to the SlyView display, and the two displays directly connected to each other by a network cable. But if I understand the network, the two displays...

When I select the "Lean" mode and pull the mixture, my CHT/EGT display will show when each cylinder peaks and the LOP delta from peak. Should it also show the delta from peak if I advance the mixture to ROP? It always reverts back to the actual EGTs. As I read the manual it seems as if it...

After upgrading to V13, I've noticed that the system does not remember the previous MAP layers selection. I normally fly with the sectional displayed and now I have to re-select SEC on every flight. It used to remember the selection and I never had to re-select. Am I missing something, is...

I would like the option of setting my 10" screen to 40% PFD and 60% Map. When cruising at altitude the larger Map would be useful. Thanks

The "Fuel at Waypoint" info item is useful  but I would also like to have a "Fuel at Destination".  I can calculate it now with the available information, but it would be nice to have a direct readout.  As long as a flight plan is entered and active all the required information should be available.

Should Virtual DME work with the SL30 selected as the source for Bearing 1, or does it only work if it is the HSI source? I've tried it as the BRG1 source but can't get it to work.

The VP-X manual implies that wigwag can be turned on or off from the Skyview. I can't figure out how. What am I missing?

I've installed 2 SV32 standard arm servos in a flying RV-8. Have successfully completed all Calibration and Test procedures. During the Set-Up process the manual says to set the torque at 100% and attempt to override the servos. When I do this in both pitch and roll, I am able to override...

Wired the light per page 7-51. Trying to complete the EMS sensor mapping, but pin C37 P20 does not show up. How/ where do I insert C37 P29? Terry

I'm installing a Skyview system in flying airplane and the Dynon EGT probes extend out too far and will interfere with the cowling.  The probes I removed had a 90° bend in them.  Is it OK to bend the Dynon probes the same way or do I need different probes?