Search results

I’m in the process of building a Jabiru 430 needing 4 place intercom to go with my dual dynon radios. Although I’d prefer all Dynon to go with all the other instruments I’ve got to go with a non-dynon dedicated 4 place - planning on a PM1000 II anyone got a circuit diagram for a working set up...

I’ve recently replaced my Dynon SV1100 in my Jabiru. It was a simple swap in a fully functional setup. The old SV1100 has some minor issues that require it being sent back to the factory. I had access to a new SV 1100 still in the box. So all the modules, battery and attachments etc are all...

Tried this feature out today and immediately ran into a problem of the autopilot selecting wrong airport and I can’t work out ( nor can I find any instructions) on telling it to drop the selected airport and go to the next nearest. I’m in a wheeled fixed wing and the emergency glide keeps...

I’ve got multiple issues that have arisen with my Skyview HDX (about 5 years old). Intermittent faults - screens (left half of screen - EFIS Display and Engine systems bar across bottom ) go black with red crosses and says ADAHRS Fail and EMS Fail. Also “Touch Screen Error” used to occur...

I’ve got a Jabiru 6 cylinder engine all set up and apparently working in my skyview HDX Ive got a spare Dynon OAT type probe (with two wires -one white, one black and white. ) Tried to install it as a cabin temp probe connected up to pins on the 37 pin input. I selected a ground and (I...

I updated my Jabiru with the newest Dynon HDX update and it seemed to load properly. But now I have no temp sensor inputs ( either CHT or EGTs). When it boots up there is an instantaneous display that shows red crosses on each of the numeric blocks where each temp should be displayed. Then the...

I am planning an upgrade in my Jabiru 430. I have a functioning Skyview HDX with knob and AP panel. Looking to add skyview radios. Issues are: I need four place intercom I need dual radios Need advice as to what set ups users may have that will fit this need. My reading seems to indicate...

Have had my sky view HDX with knob panel and Auto Pilot panel installed for maybe 18 months or so. Till now I have had the AP set up in simple mode and no problems. Yesterday decided to step it up to Expert mode. Did that OK. Now notice a couple of things: 1. When I press direct to command...

Hi All. I have noticed a few issues and need some advice on them. I have a Skyview HDX with autopilot, knob panel and autopilot panel, a network hub in a Jabiru. Installed it all a year ago and some issues have been present whole time and other have started more recently. Most are intermittent...

I need to delete some of the widgets on the bottom engine bar. I have the downloaded Jabiru 3300 engine file installed on my HDX but I don't have some of the things that are shown and I need the space and would like to delete their widgets. Eg. I don't have electronic fuel gauges (I have glass...

I have my new HDX setup on the bench. I have connected up the battery and got the messages that a battery test was needed. I got into the battery status page which said that a battery was detected, previous shutdown was normal, a test had not been done and was needed and that the battery was...

Need advice about a problem. Essentially my D180 flicked into a grey screen while flying today and that's all I get. Background- was flying and engaged autopilot ( all Dynon components AP74, servos etc) - oil temp became erratic. Turned off autopilot and temp stablized. Did a few rechecks...

My apologies if this has been covered elsewhere but my search turned up a blank. I have a D180 attached to an AP74 and two AP servos. I have just reinstalled them after a cabin refurbish and now the screen is really dark. All attempts to make it brighter ( less dim) using the on screen...

I've got a D180 updated with latest firmware. Has been fine in all other aspects but the data files seem to be consistently corrupted. This is first time I've used the data retrieval files for ten years or so so I admit I have probably done something wrong. When downloading saved data using...

I have a 10 year old D180 Flite Dek in my Jabiru and have decided it's time to do a complete renovation and bring my dash up to the latest. I'm curious to know which bits I can or should keep and what needs to be replaced. I have a D180, AP74, external Dynon magnetometer, 2 Dynon autopilot...

Had an interesting problem occur today. My AP74 seems to not be getting GPS associated data from the D180. It previously worked well. My D180 gets data from my garmin 296 which is displayed on the 1/3 page with HSI etc so I know the link from the GPS to the D180 seems to be OK. And the AP74...

I had to change my firewall forward fuel lines in the Jabiru (2 yearly requirement) and have now run into the same problem I had way back when I was first flying the aircraft - namely the old fuel flow sensor reading way-high in the climb-out and when in some attitudes. I came to the...

Had a problem arise a couple of days ago. After an hour or so of flight I got a hum in my Headsets then intermittent crackling. I noticed the lights on the AP74 blinking in time with the crackling. When I landed I opened the panel and jiggled all the connections. None were overtly disconnected...

Second problem with my newly added pitch servo. I have two micro-air 760 radios with a PM 501 intercom. I have a separate switch in the power line to the servos. When I power up the servos I now get a coarse buzz/static in my headphones. Goes off when I turn the servo power off (but rest of...

I have finally got round to installing the pitch servo in my Jabiru and have a couple of problems. The second I will post as a separate issue. First. I keep getting a Broken Disconnect Wire warning coming on. It seems to happen every 30 secs or maybe every minute. Checking the wiring - it is...