Search results

I went to the airport today to do some work on my airplane which included this update. Found the USBs don’t automatically read chart data at boot and my sticks need the old out-in exercise to work 100% of the time after a system boot. @djones I'm almost done getting this radio in, it...

Coming in from underneath I’m in alt hold mode with vnav armed Glide slope comes in and captures Airplane flys straight through glideslope. Works fine on RNAV approaches. Airplane is a Glasair 3 and the default settings have been fine for me with minimal complaints other than this. I’m...

Ok I’m stumped. New install on a Glasair 3, trim via a Linear Actuator rated at 3 amps (so no trim amp) Nothing out of control panel. I disconnect the motor and put a meter on it while commanding the motor via the panel, no voltage observed at the motor. Pull the pins from the connector and...

This thread is meant to be a small annoyance to whoever sees it reminding them that - we're waiting.

I have been complaining to Dynon about this for a while, but at this point I don't have a lot of confidence in the code behind the dimming functions, to the point where now I believe it's a safety issue. I routinely fly over the everglades at night. So far I have never been able to get the...

When I build a flight plan everything is fine and normal and hit's works as expected. When the IFD is set up with a Direct To, For about a half a second I get HITS then it dissapears. Anyone have any thoughts?

engine_type=ENGINE_LYCOMING engine_type_uses=ENGINE_TYPE_USES_CHT horsepower=180 redline_rpm=2700 cruise_rpm=2400 tach_time=615423843 hobbs_time=15425033 rotax_engine_time=0.00