Search results

EFIS clicks off with a noise similar to that of holding pwr button on a laptop for hard shut off, and reboots immediately. Problem started intermittently and has become more regular in last couple of flights. Most times it goes directly to black and white basic screen and at other times it...

Got replacement servo within 24 hours. That's being expeditious! New servo works perfectly. Autopilot trim messages occur as per config instructions. This is a nice VFR AP for smooth to lightly turbulent air. For a straight combination of EFIS/AP, it navigates very well with direct Garmap 296...

Hi, As a precaution, I replaced my original twisted wire with a shielded company made one with the shielding grounded at each end. No change observed. I uploaded 4 short videos, 3 made on the ground and 1 in the air. 1.   http://vimeo.com/5830045 Pitch servo static 2.  ...

Thanks, I will advise.

Thanks you for your promt replies. On my flight test this evening, ground activation of ALT with the stick centered and neutral( the elevator is statically balanced and the stick remains centered by itself) produced within a few seconds the AP UP signal. Servo clacking is present. Application...

I will flight test the AP again and try documenting with video. I have already videoed the stick jitter that I reported.

2nd photo

Attached are pictures of the plane and the AP installation. Also, I have made 3 short videos today which I will post on the video sharing site - VIMEO asap. Overall motions of the controls are normal. It is while it is doing its fine work that this problem shows. The very small stick mouvement...

Just installed SV32s/D100 in my original homebuilt. After config, the pitch servo and, to a lesser degree also the roll servo, jitter almost continuously while holding ALT and HDG on the ground, and the pitch servo continues to do so in the air regardless of sensitivity and Q. This happens...

Re: Course only shows North and losing link to AVM Thanks Brantel, I hadn't read your reply before posting my last.

Re: Course only shows North and losing link to AVM The Advanced setting: Normal fixed the problem. The EFIS works fine with the Garmin X96 series without the strings mentionned earlier.

Re: Course only shows North and losing link to AVM Thanks, BRANTEL I will also check the setting is Advanced - Normal. Other than that the setting is correct.

Re: Course only shows North and losing link to AVM I guess I found the answer to my observation. Re-reading the D100 installation manual and the GPSMAP 296 ops manual, I found that the EFIS needs one of $GPBPD or $GPAPB in order to show current CRSE on the OBS. Perusing the various X96 series...

Re: Course only shows North and losing link to AVM I also have the same problem of CRSE always showing 360 with my new installation of D100 coupled to GASMAP 296. I will check same. C-GMPU