Search results

Hello, I have installed a D100, D120 and RV9 roll servo. When I have applied power, I couldn't have a DSAB connectivity. I have noticed that when I pulled the servo circuit breaker, I could recover the DSAB. So I have disconnected the DSAB pair going to the servo, and the DSAB was fine. I have...

It does , thank you :-)

When changing the default setting to °Celsius and litres, I find those units to be °Fahrenheit and gallons after power cycling the D120. I thought this would have been saved into some kind of a flash memory. Is perhaps the keepalive connection needed ?

IN EFIS D100 installation guide page 2-2, the serial interface female DB9 is showed with pin 2 = TX and pin 3 = RX. On a regular RS232 DB9, it is the opposite. As D100 pin 22 is RX, it is logical that DB9 pin 3 would be TX as in the regular RS232 DB9 pinout.

This post is addressed to our dear moderator Dynonsupport. In a future upgrade, does Dynon plan to add a second output for a warning light ? It would be nice to have one light for urgent alarms, and another one for non-urgent alarms. Kind regards,

I'm about to install the fuel flow sensor, but two points are unclear to me. If I understand, it has to be installed horizontally, to get the wires pointing straight up. Is that the case ? Other point, there must be 6" of straight fuel line before and after, and after, the fuel must travel...