Search results

I have seen the 5nm indication change to 1nm when flying in OBS mode but not always and may not be due to OBS mode. So I know it can change, but cannot figure out how and why it works. Here's proof:

I am helping a friend with an RV-12 equipped with a Skyview Classic. He bought the aircraft used is on the learning curve. I also have an RV-12 with dual Skyview Touch screens and am pretty familiar with the SV and so am helping out a hangar pal. It appears the autopilot on this -12 has never...

Can anyone post a screenshot of what the EMS widgets look like like after the 15.3.4 SVT update.

SV Classic Pilot's User Guide - Rev X  page 4-25

Replaced the USB 3 remote panel mount with a USB 2 and now it works. I suspect my USB 3 not working is due to it being a low quality component; they are $15 items made who knows where.

I installed a panel mount USB 3 connected to the rear USB ports on my SVT, ver 14,  and it doesn't seem to work.  Am I correct in assuming USB 3 is not supported and I'll need to replace the remote jack with USB 2? Simple question I know, but unable to find the answer in the manuals.

Dynon, can you say if the Fall release of HDX is on schedule?  I ask because I am about to begin a SV panel upgrade on D-180 RV-12 and have a fair amount of preparation to complete but don’t want to have the aircraft sitting for several months and would wait to begin if HDX is delayed. I know...

I would like to resurrect this thread to ask if the RETRN FLOW parameter is only applicable if there is a second flow sensor in the system to measure return flow? Tony

I need to charge my D180 battery and have read this thread with interest.  The charging procedure seems clear, except my regulated battery charger starts out at about 14.5 volts and tapers off to about 13.5 volts as the AC main battery becomes fully charged.  If I boot the D180 and then power it...

Hello, My installation includes a D180, AP74, two servos, and a D100 all successfully communicating via DSAB.  My laptop communicates with the D180 com port successfully. My question is, to upgrade to the new 5.3 software, can I upgrade  all of the equipment thru the D180 com port, or do I need...

I would like to run my new D180 on my bench by wiring a 25 pin D-sub pin 1 Master Power and pin 3 Master ground and connecting to my bench regulated 12V dc power supply. Also, I would like to make the pins 9, 10, 22 connections to a 9 pin D-sub so I can connect a laptop and work on checklists...