Search results

Trev, Very similar configuration. Skyview, Garmin 695, GNC 255. Before bother you with details, would you please to give us a short hints like connection types, features you have. Thank you in advance.

Hi All Can somebody tell me, the list of known working features between SkyView and 255 depending on connection type (RS232 and/or ARINC 429)? Thank you in advance.

Hello, Yesterday I check the AP power and find a fuse has been blown. :-[ No more Pitch and Roll error. After SkyView NET configuration both servo has been detected. One of them have a yellow message CONNECTION FAULT 4/8. From other topics I understand the V4.0 started to use and monitor...

On SkyView AP earlier worked fine. BROKEN LINE DETECT set to OFF. During AP flight the AP stopped to work and in same time both ROLL and PITCH ERROR appears. After flight I check SkyView network status and see both servo reports error. I go for network config, and both servos disappears from...

Hello! In SkyView menu Local Display Setup/Installed databases I find Aviation databases: Avdata …. Jeppesen Worldwide Obdata …. Jeppesen Worldwide Can someone explain me (I am Europe customer) this databases are OK for me or I must purchase Jeppesen Europe databases?

Thanks! :)

Hello! The location of SkyView USB port (back side of the Panel) is not user friendly when the panel is finally installed on fixed position. Is there some Dynon approved solution for better accessibility of the USB port?

It is perfectly clear. Thank you Dynon Support. :)

     I am new on Forum and sorry if I post on wrong place. I started the topic with name 'AP with skyview ground test'. In you reply you talk on D180, D10/D100 but no about Skyview. Please tell me: I need to be sure that after starting AP over CWS mode (with disngage butto hold more than 2sec...

Where is a 'Sync on Engage' in Setup Menu? As Steve W. sad about ground test, I know only the 'AP test' provided in AP setup menu. Is there something else?

Hello! AP calibration and AP Test OK. On the ground with engine off, I tried to engage AP with disengage button in CWS mode (button function set to, hold to engage YES, enable broken line detect NO and CWS mode HOLD HDG/ALT). The result was AP servos goes to maximum turn and produce very hard...