Search results

Thank you for your interest in my post - It's seems a common problem [ you are a better VAF searcher than me ;) ]. I asked Van's and they say not to change the original AN470 rivets (despite 0.063 thickness of the bell crank), anyway there are only 2 or 3 to change only ... For sure it's a...

Thank you Jake for your answer - The brackets for the bell crank are the original kit sold by Dynon (DYNON AUTOPILOT PITCH MOUNTING KIT FOR RV 4 / 8 pn: 101020-002), no cut done. The tech drawing is mirrored respect my photo that is taken from FWD to AFT of the aircraft.

I tried to install a brand new SV32 pitch servo into an RV-8, pre 2006 - not prepunched. I strictly followed all the Dynon product Information respecting the drawing but I jumped into a NO-GO situation. The elevator bellcrank bearing rivets are not cleared with the retention bolt of the servo as...

Hi, thanks a lot for your feed back. RPM : I have connected the signal wiro to the Pin 32-white/green/ standard left as per instruction. under ems/engine information I choosed lycoming/4cyl/180hp MAP: I'm using your sensor (with Weatherpack connector), Map value has small changes with engine...

Hi, installed a Skyview system in a brand new RV-7. Today first engine run. EMS from Skyview gave me 3500 rpm @ idle with 32.4 Map value. I searched a lot into manual and Skyview setup pages but I loose Have you an idea ?

that's the setup device found

I checked for the first time the skyview network into the airplane. the setup is : - 2 adahrs (200 - one is for backup) - 1 EMS - 2 display 700 (only one is connected for this test) I run the device setup that performs perfectly and all the items are found BUT I continue to see only triple X...

Hi, I bought an A/P kit for my Dynon D10A (yours kit). The instruction says to use the 5" linkage to connect the aileron bellcrank to the servo but into the kit there is a 2.250" linkage tube (insufficienty to reach the 5" requested lenght with bearing) . Missed I something ? Thanks

Hi, I'm helping a friend thad had bought two SV-ADAHRS-200 instead of 1x200 and 1x201. May he use two of them linked or he has to return the product and buy a new 201 ? thanks for help