lucaperazzolli
New Member
- Joined
- Nov 11, 2010
- Messages
- 9
I tried to install a brand new SV32 pitch servo into an RV-8, pre 2006 - not prepunched.
I strictly followed all the Dynon product Information respecting the drawing but I jumped into a NO-GO situation.
The elevator bellcrank bearing rivets are not cleared with the retention bolt of the servo as per Dynon plans.
I tried all the possible standard creative work like changed the washer into an L, removing the star lock washer but nothing satisfy me in a safe manner.
One solution could be changing the AN470 rivets to AN426 but I think that clearance here is a big factor, or found a different bolt ?
Advice needed, please.
Luke
I strictly followed all the Dynon product Information respecting the drawing but I jumped into a NO-GO situation.
The elevator bellcrank bearing rivets are not cleared with the retention bolt of the servo as per Dynon plans.
I tried all the possible standard creative work like changed the washer into an L, removing the star lock washer but nothing satisfy me in a safe manner.
One solution could be changing the AN470 rivets to AN426 but I think that clearance here is a big factor, or found a different bolt ?
Advice needed, please.
Luke