Search results

I have two Princeton Fuel Capacitors one for the header tank and one for the main tank. Both are single set point and I still cannot get a voltage value change when I add fuel per instructions. Can anyone help?

I also have the Vision Microsystem fuel probes and I purchased (2) Princeton Capacitance Convertors and still cannot get the voltage values to change when I add fuel to either main or header tanks. I have had (2) experts do and reconfirm the wiring which they say is correct and still cannot...

I have a Glasair III and tried calibrating the fuel yesterday and as I pumped 5 gallons at a time and pressed add I noticed the voltage increase each time. When the fuel tank was finally full, I pressed the full and accept buttons and the Skyview said unable to calculate. Any ideas why? Thanks...

After installing the Dynon SV GPS 250 in order for the map page and synthetic vision to show up on the screen, I have now lost the ability to use the Garmin 480 as my GPS 1. I have gone over and over the settings and have checked the ARINC 429 to make sure it was flashing (operating correctly)...

Great, thanks!

If I purchased your SV-GPS- 250 would it work together with the 480 so I can use the 480 for my flight planning and HSI and if I want to fly a GPS or ILS approach with the 480 would I still be able to see at the same time the Map page and Synthetic Vision on the screen?

If the HSI is now properly working shouldn't the map page work? I still get a blank screen with and airplane icon and flashing ? I wonder if I need to re-install the firmware and then the software? Any thoughts?

Yes the serial wire is connected from the 480 out to the ARINC and the 480 has Lat/Long position accuracy: <1 meter RMS typical with WAAS (horizontal/vertical) and 3D lock!

I have GPS lock but how do I know I have a 3 D lock? The unit itself is working fine and the installer and I re- checked pin for pin according to  the ARINC 429/Garmin 480 most recent wiring diagram! We spoke with Steve in Tech this past Friday and configured the settings as he told us but still...

Would appreciate it so I can try it!! Thanks

Today the HSI nor the map would not work with the 480! It's really strange as yesterday it worked fine only the map page wouldn't work.  It's connected via ARINC 429!!

I finally have GPS lock and the HSI is working but I still have a blank map screen with the airplane and ? mark flashing. Also when I went to the nearest airport on the Skyview it showed that I was in Washington State 2,326 miles from my position. The HSI was correct as I had the GPS direct to...

Thanks for your help and good flying!!

No!

Only the 480 providing the position!

I'll look into it, thanks! Rick

I just installed my new Skyview system and set up the Garmin pins according to the installation Manual but get a blank screen with the airplane icon and a ? mark. Can anyone help?? Also, the synthetic vision doesn't seem to appear on the PDF! Thanks, Rick

I recently finished the installation of the Skyview in my Glasair III which had a VMS 1000. I"m unable to calibrate the fuel tanks! Is the VMS fuel probe system compatible with the Skyview's EMS? Thanks, Rick