Search results

Thanks, I will try that.

I have lost the ability in V16 to select altitude from the control knob and touch function for autopilot any ideas If this is something I can change in the setup menu ?

I am having trouble with 10" Skyview classic touch functionality when the screen has light shining on it in flight. The touch feature is unusable once the screen heats up and the touch input dot starts chasing across the screen, has anyone else had this issue ? The 10" screen is installed in a...

The idea I am trying is to aggressively lean the engine to L.O.P to get through the worst engine operating area around 50 R.O.P. Then you can richen back to peak egt then lean again to avoid that area for L.O.P or decide to operate R.O.P by richening quickly avoiding that area again.

Can the lean find mode on Skyview be setup to operate from the L.O.P side back to the R.O.P which is better for the engine ?

Thanks, will give that a go .

I use the Skyview Classic touch in six pack view, when the airspeed goes above 90 kts the indicated airspeed in digital view in the centre of the airspeed indicator is highlighted red even though all V speeds are entered correctly in setup and vne is set at 182kts. How do I correct this ?

Thanks, I will run some tests with an electronic fridge thermometer and tape the probe under the wing. I will compare results before I commit to moving the Dynon probe.

Tucked under the cowl cheek I guess it was install ed so wiring does not need to be extended.

I just want to make sure it calibrated correctly, I am going to check it with an alternate temperature sensor. The sensor is mounted on the side of the fuselage on an RV3B.

Thanks, I suppose if I had the installation guide it would be easy to look up !

Where do I look in the setup menu so that I can adjust the outside temperature probe ?

Thanks, I will look at wiring, have tried different headsets and that made no difference.

Hi all, Have purchased a new aircraft with Dynon Skyview and comms which receives transmissions really well but when I transmit my readability is less than 3. I have tried adjusting mic gain in settings but still no improvement. Any ideas for a solution would be appreciated.

Trying to connect d100, d120 to laptop to upgrade sowtware via db9 rs232 / usb cable cannot get it to connect. Is there another way of connecting to the system ?