Search results

  1. N

    A/P control panel issue after 16.4.4 installation

    Recently installed 16.4.4. Expert a/p mode. I routinely decouple trk/hdg with the ap panel basically leaving a/p in altitude hold while I meander around the sky viewing the scenery or allowing a passenger to steer the aircraft. After 16.4.4 the trk/hdg buttons will now not disengage either mode...
  2. N

    Obstacle alerts

    Is it possible to have obstacles, ie antennas to have audible alarm? I purposely flew with 1/2 mile of one that I was slightly below the top and never got an audible alarm. Yes, the antenna was red on screen. I looked through the manual but was unable to locate a reference to this.
  3. N

    UL Power fuel consumption

    When I set up Dynon EMS about 4 years ago, the only digital solution for fuel usage was was injector pulse. Now that Dynon can interpret data for RotaxIS is there a way now to interpret from UL Power ECU the pulse/liter data stream which would be mostly accurate at all power levels?
  4. N

    ADAHRS failure

      :'( A great morning to head for breakfast and this is what I was greeted with. Removed power to reset system and after reboot greeted with the same warning. Went back to hangar later to see if ADAHRS was active on network. When energized.....all was well. Anyone experienced this and if so is a...
  5. N

    Screen detail

    I ran across this photo on barnstormers and would like to know what the box in lower right is. I have never seen this on my screens and would like to know if I am missing something.
  6. N

    sensor configuration

    I want to add a new sensor definition to the .sfg configuration file I have no problem adding. However when saving file, I am unable to save as .sfg. I am near certain I have done this a few years back but do not remember what I did to complete the task. :-/
  7. N

    green trim indication

    How does one move the green take-off trim indicator to a new position? I do not have the auto pilot panel, if that makes a difference.
  8. N

    MAP sensor

    Should the MAP sensor reading match the barometric pressure from the ASOS when engine is not running? Mine reads .5 different.
  9. N

    Fuel consumption via injector impulse

    :DNow that the com and intercom have been released, maybe you will have time to work on integrating fuel injector impulse to the EMS for fuel usage monitoring. Would be a great improvement over using two flow meter/transducers and trying to get the k factor set. Anyone else having need for this...
  10. N

    circuit monitor

    :-?How would one monitor a non powered circuit to ground and monitor through the EMS? Would be monitoring for a break in the circuit. Thanks
Top