Search results

hi all, what was the issue of this problem ? i had the same problem yesterday with my D10A after 4 month off. when i start the D10A, the altitude was right but when i start the motor, the altitude falldown to -1200 ft. I check all the static lines wich seems good but cant do an another test due...

Thank's for your Answer The D10a seems to be perfect Best regards

Installation is done, No yellow wire on my harness And no pin 2 for keep alive power installed. The alone yellow/Green wire is for the gps connection I dont know what is the black/white short wire on the harness

Hi I install my new d10a without edc10a, when i start it for the first time, it said REMOTE COMPASS NOT DETECTED, but i dont install an edc10a and i never connect one. The firmware was 5.5.0 first, i made the initialisation on the DSAB and it said that i was in stand alone mode, after the...

Tanks Jake J for your answer The pin 2 is not connectes on my harness I Will Check if the yellow/Green is realy connected to the gps pin before connect it. I found a post on an dynon ems harness wich have the same observation Than me on my harness. Is the dynon ems harness is the same Than the...

The manual describe the yellow wire, it dont exist on my dynon cable, that's why i wrote this message regards

Hi evry body, i just brought an EFIS D10 A and a Dynon Cable, it seems that there is no yellow wire for the keep alive power on it ! instead of that i see an yelow/green wire but i think it is for fhe GPS connexion. thanks for your help regards