Search results

  1. D

    EMS D10 pressures,cht's blinking prior start

    Sorry for the long delay but I thought this forum would notify me of the reply to my initial question and did not check this site. I'll send a video to support ASAP. Thanks, John
  2. D

    EMS D10 pressures,cht's blinking prior start

    With initial power up and prior to engine start, the D10 EMS has blinking fuel/oil pressure and cht/oil temps. I have tried to disable the alarms numerous times as per 5-3 of the installation guide but have had no luck. Once again, these blinking lights occur as soon as the power comes on...
  3. D

    D10a and Becker BXP6401 set up

    It turns out that two wires on the Becker harness I purchased were in each others pin. The other problem was that there was a ground on one of the db connectors that, due to my panel setup, should not have been there. The BeckerUSA tech guy was a big help in helping figure this out by offering...
  4. D

    D10a and Becker BXP6401 set up

    The link below is for the Becker transponder if anyone would like to take a stab at it. Much appreciated. THX, John file:///C:/Users/System%20User/Downloads/BXP6401_I&O_issue05%20June%202018.pdf
  5. D

    D10a and Becker BXP6401 set up

    Hi Guys, What is the set up for a D10a and Becker BXP6401 transponder to enable altitude encoding? I've tried just about all the variations on both boxes. The transponder check failed. I get a Becker Error Latch of DATA LINK and of course FAILURE showing up sooner or later. Thanks, John in MN
  6. D

    Connect IFLY740 to D10A

    Does the information wire from the IFLY740 go to serial port (DB25)? EFIS-D10A Installation Guide p 3-4 P 3-4 of the Guide "The following connection schemes assume that the external devices share a common ground with the Dyonon product(s)" I have the IFLY740, D10A,EMS D10, Trutrak a/p as...
  7. D

    IFLY 740 and D10/D10A

    Hi Guys, wiki.dynonavionics.com did not discuss the IFLY 740 and I'm wondering if my ifly 740 will work with the D10A and or D10 I'm now wiring up. Thanks, John
  8. D

    Power fuse size D10 EMS

    Thanks Ray, I suppose if I had read the entire manual(which I have just printed out) I would have found this answer. Sorry to waste your time. John
  9. D

    Power fuse size D10 EMS

    What size fuse should I use for pin 1 on my D10 EMS. "appropriately sized fuse" on page 4-1 in manual does not help a newbee at electrical stuff. Thanks
Top