Search results

I would like to know if it is possible to upload my old (use D-100) information in a brand new D-100. I had tried it and the systeme refuse because it not the same serial number. :'( Pierre

Hi. Today, after 2 months, I put my master on, to check  the battery voltage on the EMS, normally the EFIS and the EMS come on. But after a few second I lost the EFIS(D-100). I check the batterie back up and no voltage on it. I had disconnected the battery back up and I tried with the master but...

Thank you

Presently,what is the delay to ship the servo? I have a Glasair 11SRG and I would like to know what is the model I need? :-/ Do you have the hardware for the Glasair 11SRG?

I would like to know if it s possible to connect my PCAS to my Garmin 496 and do not loose my HSI on my D-100 in the same time. :o Pierre

I would like to know if i need a converter to connect my sender to my dynon EMS-100. My sender have 3 wires 12 volts-output-ground. I try to verify what kind of signal at the output. It`s not ohms and not a voltage. :-/ Pierre

Thanks :) Pierre

HI Yesterday, I had started  my EMS-120 for the first time  and I think all the sensors are in the good ranges but I can  hear a noise like a relay or breaker every 4 seconds in my EMS.   :-? Is it normal ? Pierre

Thanks for the prompt reply. :)

On page 1-4 of the EMS D120 installation guide,we see the 37 pins femele EMS connector. My question is: Is this view the front end or the back end of the connector :-/ Another question about the fuel flow sensor: I have 3 wires comming from the 37 pin harness(red,black,yellow) and on the...

What the delay of the delivery if i place an order for the D-100 and EMS-120 with the bright-screen option. Pierre