Search results

Got it taken care of! Thanks :)

Hello, I have been through the start menus and manual to try to find the correct setting. How do I configure Skyview so that the PDF + Map are displayed upon startup. Currently, the PDF loads fullscreen and then I have to hit the screen map button to toggle through the various PDF+Map split...

My wife's airplane has a Dynon Skyview and I use the autopilot in expert mode when I us it. No Autopilot panel. I'm building a VFR airplane, open cockpit. I plan on using the plane for X-C flight aside from local around the path flying. It the Autopilot panel useful for VFR flying? Or is it...

In open cockpit aircraft I have owned, I have used the PS Engineering PM1200 intercom designed for high noise environments. I have run them with Push to Intercom buttons on the stick along with mic muffs. The system works pretty well. Can anyone comment on use of the SV-INTERCOM-2S for use in...

Thanks Carl for the detailed reply. Can I get the comm and transponder through a Trig dealer? Or since it is branded Dynon, do I need to go through a Dynon dealer? Thanks, Glenn

Is the Dynon SV-Comm sold today the same radio as the one sold years ago? I remember many problems with the original version and knew several people who replaced them with better radios such as Garmin. I'm working on a homebuit right now and I really like the user interface on the SV-Comm... I...

Found the settings! Thanks!

I'm in the process of learning to use expert mode. I'm trying to command a climb using IAS. I was expecting to see IAS on the joystick knob list in the lower right but it's not there. How do I adjust the airspeed bug? Thanks!

Scenario: Departed airport, turned on course, and climbing to clear airspace ahead. GPS destination set. While in the climb, I would like to engage the autopilot, either on TRK or HSI, without any disruption to my climb to my target altitude. If I engage the autopilot into either the TRK+ALT...

I have +/-500 fpm set as my vertical speed. In simple autopilot mode, is there a way for me to command a climb or decent at a rate other than what I have pre set? In other words, I want to temporarily override the programmed +/- vertical speed. I thought this was through the BUGs screen but I...

D180 AMS Audio Alert Output I have DB38 Pin #31 (EMS Audio Alert Output) wired as shown utilizing the 10 kΩ variable resistor. The center terminal is connected to my Garmin GTR200, AUX MONO IN 1 The Garmin has an AUX 1 LO terminal as well, but there is no LO or Ground signal from the D180...

I was however able to tell the D180 that one of the coolant temp probes was a CHT and got it to display on the 1/3 EMS main page as a CHT, however its value is about 10 degrees lower than the other coolant temp probe. Would love to know if there is a way to adjust this.

I spent some time on the phone today with Dynon while I was at the airplane. We can't move the GP-1 Coolant temp widget to the 1/3 EMS main page. We found a note in the D180 Pilot User guide (not the installation manual) that read... "EMS Main Pages Available in 1/3 and 2/3 formats This page...

Hi, I prefer a flying a 2/3 EFIS & 1/3 EMS screen (JPG 1) Is there a way to move my coolant temperature (GP-1) over to the 1/3 screen EMS? The coolant temperature only shows up when I have the panel set 1/3 EFIS & 2/3 EMS (JPG 2). Engine is a Rotax 912 ULS, 4 EGTs and 2 Coolant probes. The...