Search results

graph showing session time vs volts/avx amps

Good thoughts Bob, I do have the backup battery installed - functions correctly (screen stays on during cranking and for "power off countdown" after master goes off) the dynon logs show the system voltage did not fluctuate during the events, the last data frames before the re-boots from the...

I have been flying behind Dynon screens for several years now - including IMC. This event has shaken my confidence in Dynon for light IFR - this could have been fatal if I was in IMC at the time. How common are these re-boots? Is it a matter of not using any USB devices or just a dice roll...

Flying level in VMC, my single HDX screen went black, and re-booted. Came back in about 1 minute, 5 seconds later re-booted again came back, re-booted again in about 5 minutes. Screen came back - and functioned normally until landing 15 minutes later. The screen reported system event 3 in...

Pm sent - I’m interested

This is a solid bit of information - thank you for the clarity. I suggest you copy paste this into the GPS wiki and into the HSI source info table in the install manual. Dynon support is loaning me a SV-GPS-250 to test (thank you). I suspect this will be the solution to my troubles and get...

Hello, 2020 compliance is not a factor as adsb out is complied with separate, outside of the Dynon setup. More important than 2020 compliance is the fact that gx-60 is ifr certified for enroute and non-precision approaches. the hsi does work - however position is not shown. where in you...

I can’t get my gx-60 working with skyview. It looks like Dynon added support for the Apollo gx-60 aviation message format in 11.0, however I am have a terrible time getting my new sv1000 to accept the complete MOVMAP message from my gx-60 the Dynon serial port diagnostic page shows no message...