Search results

Thanks for the quick reply, the Gretz mixer sounds like the answer. The SL-30 Intercom works well in my little 2 place GP-4 so don't see a need for an audio panel. John NZ

I have an SL30 Nav/Com with the built in Intercom and no Audio panel. As far as I can see the SL30 has no facility to connect the HS34 Audio Output. Can I connect the HS34 pin #25 via a variable resistor diect to one of the SL30 mic inputs? Thanks John New Zealand

I am useing a pair of westach 395-5s sensors with my D-120 and they work fine. The sensors require a 12V input from the same switched supply that powers the Dynon and Fuel Flow senders etc. The output is 0 to 5v ( 0v empty & 5V full) and these are  connected to the D-120 Fuel Level Inputs. I...

Re: Magnetic inclination and intensity for New Zea Leonard, When entering your magnetic inclination note it is minus in this neck of the woods!! I have just been caught out with an erratic compass due to having it in as a plus figure. The Install. guide is not very clear on this. John Blenheim...

Have just fitted a D-100 and D120 to my Subaru poweres GP-4. Could do with; 1. An additional input for a 3rd capacitance fuel gauge. 2. Another Amp input. ( I have duel electrics & at present switch betwwn the two) 2. An additional temp. input for Reduction Gear oil temp.( again am switching...

Done all that! I got all numbers reading 2.75 but can't get them any higher. As I said, I am pretty sure the numbers are bar not PSI for some reason? However we set the colour bars were we thought they should be and yesterday I ground ran the engine and found the gauge read OK showing 14PSI so...

It appears to us that the GP2 input set up page is showing Bar not PSI, hence the max. reading of 2.7 for the 0.30 PSI sensor? I have not flown it yet so don't know what it will show on the display. In Global I set all pressure readings to PSI. Any coment would be appreciated. Thanks, John.

I am installing a D-100 and a D-120 in a Subaru powered GP-4,one or two small problems have surfaced. The first is Coolant pressure, I have fitted a 100411.000 sensor to GP2 input, the resistor is fitted as specified and all wires check out OK. The sensor should give a 0 to 30 PSI readout but...