ems

There is a requirement for a dedicated EMS-primary screen on the twins. All the important stuff can be put on the EMS bottom strip on the PFD. The Dynon Baron example install has the EMS screen above the power levers. I’d like to put it on the right side of the panel and move some other stuff...

When you install a second EMS, the install manual only references utilizing the additional EGT/CHT inputs. Can ALL of the general purpose inputs be used? So, can I have 24 or so useable general purpose inputs? Furthermore, is there any way to interface inputs like flaps, gear position, other...

Seems odd but have an intermittent problem with the EFIS displaying %power and fuel flow. Nothing I do with the display fixes it. The Dynon is earthed to a forest of tabs on the firewall and rest of the EFIS is working fine. This unit was returned to Seattle in January this year as something...

I'm installing an external EMS Warning light (LED) as depicted in the Installation Instructions. The install manual (page 7-75) states the following: Aircraft Spruce P/N 17-410 is an example of a light that will work for this application. An LED and resistor in series will also suffice. If you...

hey all, finishing up a 1981 YAK 52 SkyView installation and I'm having issues with CHT6 & EGT 5 reading negative. I have tried swapping wires at the sensor side, i have swapped connections from EGT 5&EGT6 and it 'X' out on display, I have checked continuity from the k/j-type wires to the...

I am currently installing a SkyView HDX System in a Lycoming powered Van's RV-6 using the latest available documentation. This includes the Dec 21 Installation Guide and Revision C of the Typical SkyView HDX Wiring Diagram. I have 3 questions as follows: 1. The Dynon supplied EMS D37 Harness...

As the title explains when in Dual installation we switch off one display other goes to Xes on AHRSS and EMS. AHRS comes back in few seconds on full-screen mode. There is no Engine date. Both displays have the same behavior. When both displays are on all works, can SWAP displays both sho all...

Workin Good