servo

  1. L

    AP Disconnect Button with Optional Resistor and Trimamp

    In Figure 138 of the AM version of the install manual, there is an optional resistor you can install between the incoming yellow wires from the servos and the ground for the switch. This will tell the system if there is a break in the circuitry. If you also install the Trimamp (I need it for...
  2. R

    Servo sudden loss of torque.

    Sudden loss of torque on a servo that has seen light use over 300 airframe hours. I was straight and level in smooth air. Then the "heavy" wing began to droop, and the HDX showed "roll slip". I could feel on the stick there was no servo torque at all. If I disengage and re-engage there's a...
  3. C

    One servo installed and SV displays it as a jaw dumper

    Hallo. I am configuring the roll servo (SV42) on my RV-4. On the network status, it is read as a SV32/SV42/SV52 servo. In the autopilot setup, SV display 0 roll servo, 0 pitch servo and 1 yaw servo. Of course I installed it as a roll servo and calibrated it as a jaw servo (no possibility to...
Top