ADSB-In not showing traffic

[Schorsch]

Had an intermittent case of ADSB-in traffic targets not showing on Skyview with SV470, while Stratus showed them all. Turned off SV470 and after a (too long?) delay TIS-B took over and displayed all targets. Turned on SV 470 and the targets disappeared again. Repeat, same results. A good while later, everything worked normally again...

 

[dynonsupport]

George,

What did the ADS-B status say in the corner? Was it ADS-B OK or PARTIAL?

What firmware version are you on? Have you updated your transponder? What GPS is connected? Where in the USA are you?

 

[Schorsch]

Status was ADSB-OK, 14.2.1, XPNDR updated to latest, GPS250, northern GA.

 

[Schorsch]

I have the diagnostics file, if helpful to squash this bug (assuming it is a SkyView bug since Stratus displayed ADSB-traffic continuously).

 

[Dynon]

One more question: on the TRANSPONDER SETUP page, are you using the SIL/SDA=1 version of the SV-GPS-250 under the GPS DATA option?

 

[Schorsch]

I'm 99% sure that I do - since it was a main point of the recent upgrades to SkyView and XPNDR. You can probably see it in the Diagnostics file, if you need it?