After update to 5.1 I get a error with servos.

[loopfuzz]

I'm guessing someone had this problem already but I can seem to find it on the forum. I've upgraded the skyview to 5.1 but the servos are still stuck at version 4.0 .. How can I upgrade them? I tried running the combined update again but it didn't work. And I made sure the servos had power going to them.

Thanks.

 

[mmarien]

Check the network configuration. I had to do a network detection when I reinstalled my EMS.

 

[loopfuzz]

The servos are detected already. But shows a "software mismatch" version error.

It shows the servos at version 4.0 and everything else at 5.1.
Will a network detection fix this? Seems like I need to run a update on the servos.

 

[dynonsupport]

Yes, do a network detect and it will ask you if you want to update.

It will also update them automatically if you boot SkyView with the servos powered on, rather than powering them on after the screen.

 

[loopfuzz]

Ok, thanks. I will give it a try.