AOA Probe on Cessna 182P

[Taylorbentz]

Hi, I am installing a Skyview HDX system in our 1973 cessna 182P right now. We purchased the unheated AOA probe with the intent to enable AOA as we do a lot of short field operations in the mountains, but it's unclear what installation data to use in installing an additional new pitot on the airframe (presumably over in the right wing since the existing pitot will remain in the left wing?). I want to figure out how others have filed this, if they considered it a major alteration, and what part number they used for the mast.

Any help you all can provide would be greatly appreciated! (Any actual 337's would also be a huge bonus)

 

[jakej]

Hi, I am installing a Skyview HDX system in our 1973 cessna 182P right now. We purchased the unheated AOA probe with the intent to enable AOA as we do a lot of short field operations in the mountains, but it's unclear what installation data to use in installing an additional new pitot on the airframe (presumably over in the right wing since the existing pitot will remain in the left wing?). I want to figure out how others have filed this, if they considered it a major alteration, and what part number they used for the mast.

Any help you all can provide would be greatly appreciated! (Any actual 337's would also be a huge bonus)

Not sure on how this works in USA however I suggest mounting the Dynon mast to an outer wing inspection panel - if that’s allowed.

 

[Taylorbentz]

Bump

 

[airguy]

This is an STC install from Dynon, I suggest contacting them directly rather than the forum.