Hi
Hope you can shed some light on my A/P I have a D100 and
D120 with an AP74 and two servos, configured the DSAB
It found all 5 dynon components,I did the servo test and it worked fine, set up the servos all ready then when I press the
Trim elivator all the lights on the AP74 come on and stay on
Then a warning says AP74 connection lost and err err comes
Up in the bottom left corner of the screen then in turn the warning says pitch servo connection lost and roll servo connection lost. So I checked to see what software version
The D120 and D100 had in and the EFIS is version 5.4 but the
EMS has 5.4.3 don't know if this is a problem.or is it interference from the trim motor wires????
Hope you can help
Kurt
Hope you can shed some light on my A/P I have a D100 and
D120 with an AP74 and two servos, configured the DSAB
It found all 5 dynon components,I did the servo test and it worked fine, set up the servos all ready then when I press the
Trim elivator all the lights on the AP74 come on and stay on
Then a warning says AP74 connection lost and err err comes
Up in the bottom left corner of the screen then in turn the warning says pitch servo connection lost and roll servo connection lost. So I checked to see what software version
The D120 and D100 had in and the EFIS is version 5.4 but the
EMS has 5.4.3 don't know if this is a problem.or is it interference from the trim motor wires????
Hope you can help
Kurt