After the 300hr airframe maintanance, I wanted to recalibrate the AP servos once again. (no electical wires or connectors were removed, unplugged, etc)
1.) Reconfigured the Skyview Network in SETUP MENU > SYSTEM MENU > SKYVIEW NETWORK SETUP > CONFIGURE...
All components were found, including both servos (have only pitch and roll servos !!!)
...All devices successfuly detected and configured
2.) Before recalibrating the servos the displays shows:
And with next step, states that both servos were found:
3.) Doing the recalibration:
> FORWARD-LEFT
> FORWARD-RIGHT
> PITCH UP-RIGHT
> PITCH UP-LEFT
After this point I have the message
> FULL YAW LEFT
> FULL YAW RIGHT
Altough I don't have the yaw servo (never had) and this part in the recalibration menu has not shown up so far...???
Why do I get the YAW question at calibration ?
At this point I can move the stick left and right (ROLL instead of rudder for YAW) or just leave centered, it does not matter. I always come to the error message: "calibration failed, could not detect all servos"
Can please anybody tell me what could be wrong with the calibration ? AP used to function for years...
1.) Reconfigured the Skyview Network in SETUP MENU > SYSTEM MENU > SKYVIEW NETWORK SETUP > CONFIGURE...
All components were found, including both servos (have only pitch and roll servos !!!)
...All devices successfuly detected and configured
2.) Before recalibrating the servos the displays shows:
And with next step, states that both servos were found:
3.) Doing the recalibration:
> FORWARD-LEFT
> FORWARD-RIGHT
> PITCH UP-RIGHT
> PITCH UP-LEFT
After this point I have the message
> FULL YAW LEFT
> FULL YAW RIGHT
Altough I don't have the yaw servo (never had) and this part in the recalibration menu has not shown up so far...???
Why do I get the YAW question at calibration ?
At this point I can move the stick left and right (ROLL instead of rudder for YAW) or just leave centered, it does not matter. I always come to the error message: "calibration failed, could not detect all servos"
Can please anybody tell me what could be wrong with the calibration ? AP used to function for years...