rfazio1951
Member
- Joined
- Feb 11, 2010
- Messages
- 356
I've searched through paste posts about the wiring, but can't seem to find this. I'm using Tosten sticks where they say you need to use relays to operate the trim servos. I'm using Ray Allen trim servos, that use less than 1 amp for trim. When using the autopilot controller to run the trim servos, is it acting as a relay deck? Does the full load of the trim motors go to the stick or is it just a control circuit with some load less than the servos use. I hope I'm clear here. It looks to me like I can eliminate the relay deck when using the ap controller, but I hate to cook the stick switches.