Autopilot servo wiring

[apkp777]

I know the AP is not yet available, however I have pre-wired for my servos and can't find where they terminate to the SkyView?

Do they go to the SV-1000 or EMS module?

I understand if it undetermined. I just need to know where they will eventually go.

 

[dynonsupport]

The servo wires need to make it to a SkyNet cable somewhere in the plane. This is clearly at the back of the SV-1000 screen, but it could also be at the EMS or ADAHRS modules.

Four of the 7 wires from the servo plug into this cable. The other three (power, ground, disconnect) go where they would in any other install.

 

[apkp777]

Thanks!, Do you have the pin locations for those "four" wires?

 

[dynonsupport]

http://dynonavionics.com/cgi-bin/yabb2/YaBB.pl?num=1260713118/2#2

 

[apkp777]

Looks like I need 2 splitters. That is what I was missing. 1 SV-1000, GPS, Batt, 1 ADAHRS, EMS, 2 AP Servos.

Each item you add to the network requires a splitter.

 

[schristo]

you really only need one splitter at the adahars... just bring the roll servo wires from the wing here and tie them to the pitch servo... connect to the splitter.