According to the install manual, the contact pins 9 & 10 on the D-120 will indicate a light color in the closed state (connected to ground). If I want to have an electric fuel pump indicate as on or off, how would I wire it? The fuel pump has a maximum load of 3 amps. Can the pump be grounded directly through pin 9/10 to complete the circuit so that it will show when turned on?
Would the load be too much for the D-120 ?
How is the D-120 connected to a PC for software updates?
Would the load be too much for the D-120 ?
How is the D-120 connected to a PC for software updates?