Hello Dynon help
We previously purchased a D-180 EMS harness ( switched to Skyview)and are connecting it to the SV-EMS-220. On the 37 pin connector from the D-180 harness pins 11,12 and 30 are twisted together and have a 9 pin sub-D connected on the end. On a D-180 installation these three wires are used for data transfer from a laptop to the D-180 I do believe. Where we are using this harness for the Skyview , we cut the sub-D plug off. Pin 11 and 12 in the Skyview manual are listed as general out put " A " , and I assume they can now be used seperatly (after cutting off the sub-D plug) for any type "A " usage just like any other Type "A" ?
Thanks Ron
We previously purchased a D-180 EMS harness ( switched to Skyview)and are connecting it to the SV-EMS-220. On the 37 pin connector from the D-180 harness pins 11,12 and 30 are twisted together and have a 9 pin sub-D connected on the end. On a D-180 installation these three wires are used for data transfer from a laptop to the D-180 I do believe. Where we are using this harness for the Skyview , we cut the sub-D plug off. Pin 11 and 12 in the Skyview manual are listed as general out put " A " , and I assume they can now be used seperatly (after cutting off the sub-D plug) for any type "A " usage just like any other Type "A" ?
Thanks Ron