I purchased a 2nd hand aircraft fitted with aD10 ems & a D100 efis. I.m just completeing an engine change & install 4 EGT & 4CHT, snesor & harness supplied by Dynon. Orginal engine only fitted with 2 CHT, so need to change D10 setting in Global menu to 4 sensors from 2.
However when following installation instructs Setup > Global.
the global tab is not visible.
Options are Clock/version 4.0.4/ blank/
Reread manuel, contact Aircraft manufactuer, advised to talk to Dynon. Please
However when following installation instructs Setup > Global.
the global tab is not visible.
Options are Clock/version 4.0.4/ blank/
Reread manuel, contact Aircraft manufactuer, advised to talk to Dynon. Please