D120 Install questions

[bmiller269]

I read the manual for carb ice senor and have a question. My sensor is the blk/wht wire unit and the manual says "when using this one no resistor is needed and no additional connection is need" So is the excitation wire still needed or not?

Next both of the dynon supplied oil & fuel pressure sensors have 3 wires on them. Red,Blk,Grn manual doesn't address this. So I'm thinking they will wire as follows.
Red-12v
Blk-Grd
Grn- pin 6 & pin 8

Is this correct?

Thanks for the advise and help

 

[Dynon]

On carb temp, no excitation: Just signal (to the D120) and ground connections.

On the pressure sensors, check out the Addendum for Kavlico Sensors for the full connections. The red wire goes to 5V (pin 18), not 12V.