d180 % power and fuel pressure

craig

New Member
Joined
Jun 9, 2008
Messages
2
Location
south africa
Please could you assist with the following.

i did send a e-mail to dynon but now i was able to log on so if the reply comes via e-mail or this forrum thats ok

I have a D180 installed in my RV9 with a 160HP Teledyne mettetak motor , my questions are

- where do I find the % power setting this is such a great function but cannot seem to find it ( I have the latest firm ware down loaded may 2008)
- I would like the fuel pressure displayed on the 1/3 EMS display that has the RPM MP EGT CHT fuel flow and fuel tank levels , is this possible ?( The standard screen on power up)

Thanks.
alan
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
To get % Power, you need a few things hooked to your D180:
RPM
MAP
Altitude
OAT

With the D180, the first three are basically always there. OAT is an option though, so first make sure you have an OAT probe and it's working properly.

If it is working, go into general setup, and make sure you have engine type set to "8.5:1". Then set your HP to 160.

Once you have that all done, % power should show up next to the MAP display.

Unfortunately, on the 1/3 EMS page, there is no way to display fuel pressure.
 

craig

New Member
Joined
Jun 9, 2008
Messages
2
Location
south africa
HI
Well now i know why i insisted on a DYNON unit ,thanks for the quick response , i do have oat and i will today check this out and get it sorted thanks for the assitance and keep up the good work


alan
 
Top