fabjab
New Member
I have the D100 with the EMS D10 and would like to upgrade to the D120. This will however only show its true value if DSAB is also available. Any idea when this is planned for?
Blue skies,
Carl.
Blue skies,
Carl.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
DSAB when?
- Thread starter fabjab
- Start date
- Joined
- Mar 23, 2005
- Messages
- 13,226
Hi Carl,
Firmware that enables DSAB-based communications will be released in the coming months. Until then, the EFIS-D100 and EMS-D120 can be connected via the serial connection to enable the display of EFIS data on the EMS-D120.
Firmware that enables DSAB-based communications will be released in the coming months. Until then, the EFIS-D100 and EMS-D120 can be connected via the serial connection to enable the display of EFIS data on the EMS-D120.
D
Dave(Guest)
Guest
Will we be able to display EFIS info full screen on the EMS, or will it only be split screen?
- Joined
- Mar 23, 2005
- Messages
- 13,226
The EMS-D10 can already display EFIS data full screen and the EMS-D120 can display EFIS data in full screen or split screen mode.
This isn't our full DSAB connection that we are working on, but a limited set availible through the serial ports. But it can be done today.
The reverse, which is displaying an EMS on the EFIS, will require DSAB and cannot be done yet.
This isn't our full DSAB connection that we are working on, but a limited set availible through the serial ports. But it can be done today.
The reverse, which is displaying an EMS on the EFIS, will require DSAB and cannot be done yet.